Introduction

Basic Tools

A draftsperson needs some basic tools to draw. These should include the following:
● Pencils
● Drafter

● Set squares
● Rubber
● Engineering Compasses
● Dividers
● Drawing board
● Sketch book
● Cello Tape
● Emery board or fine sandpaper etc

Pencils : You will need a selection of pencils. A hard leaded pencil (6H) can be used for light lines, a softer pencil (2H) for the outlines. (More than one pencil of each grade will save you from frequent re-sharpening.)
Set squares : You will need at least two set squares: a 60 ° and a 45 ° set square. It will be also useful to have an adjustable set square, which will enable you to set the angle on the set square to anywhere between 0 ° and 90 ° . If you have an adjustable set square you can manage without the other two.
Rubber : Choose a good quality rubber, one that does not smudge.
Compasses : You will need at least two compasses: a small spring bow compass for small circles and one for larger circles.
Dividers : A pair of dividers is essential.
Drawing board a : Drawing boards for size A2 paper is available.
Cello tape : The tape is used to hold paper on the drawing board.
Emery board or fine sandpaper : This is used to ensure that the lead in the pencils is kept sharp.

Types of Lines